Diesel motor óleo vazamento tratamento

Diesel motores são o mais amplamente usado potência elemento em agricultura, e maioria agrícola máquinas relies on diesel motores. No entanto, diesel motor óleo vazamento é também comum. Como economizar combustível custos, please handle it wisely according to the following situations.
1. Óleo retorno para o combustível injetor: O combustível injetor é a precisão componente. Se o diesel motor usa não limpo diesel ou a máquina é usado para a longo tempo, óleo irá retorno devido para desgaste de o injetor. No entanto, since substituindo o combustível injetor é caro e antieconômico, em ordem para evitar óleo vazamento, o óleo pode ser conduzido de volta para o combustível tanque através o óleo retorno tubulação% 2c or a diesel filter can be introduzido. If the oil return pipe is damaged, you can use a section of plastic pipe to introduce the oil into your own container, filter it it and then pour it back into the tank.
2. Oil leakage in the oil delivery part: Appropriate treatment can be carried out according to the situation: the washer of the hollow screw of the oil delivery pipe is uneven. You can remove the washer, grind it flat and then replace it. If the problem still cannot be solved, you can replace it with a new one, or use a thicker soft one. Cut the plastic material into a gasket and replace it with a gasket. Oil leakage at the joint between the plastic oil pipe and the metal is mostly caused by the hardening or cracking of the plastic oil pipe. You can cut off the hardened or cracked parts, then scald them with hot water until they are soft, and install them on the metal joint while they are still hot. Tie it up with metal wire; if the metal oil pipe breaks and leaks oil, the rupture can be welded with brazing. In addition, in order to prevent the oil pipeline from rupture, when installing the oil pipeline, the curvature should be appropriate, do not force the installation, and the pipe body should not be in contact with the fuselage to avoid wear and tear.
3. Valve chamber cover leaks oil: When the valve chamber cover is installed, if the tightening force is too large, it will easily deform and leak oil. At this time, you can remove the leaking valve cover, carefully hammer and shape it with a wooden stick to make the contact surface flat, and then put a gasket on it and install it.